3D PrintingBuildsDungeon Mastering

Building Pathfinder’s “The Gauntlet”, Part 6

Continuing the series of building Paizo’s Pathfinder Module “The Gauntlet”:

Finally completed printing the third story of room two, and it’s quite massive. I’m going to go out on a limb and imagine the scenario author’s never conceived of it being printed in 3D, and what impact 30′ walls in a narrow space will have for visibility. 🙂

Mr.  Deepaxe is feeling a bit small at the moment:

Last night I hooked up my Fog Monster for a feasibility test of the room with four of the six heads connected and pumping out fog… Nothing is glued or permanently connected so the evil heads and fog streams are all crooked

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.