3D PrintingBuildsDungeon Mastering

Building Pathfinder’s “The Gauntlet”, Part 2

Continuing the series of building Paizo’s Pathfinder Module “The Gauntlet”:

For room six of the gauntlet I needed a room with approx. six 10×10 cells with a movable gates in the middle that would separate them either vertically or horizontally. Fortunately the Fat Dragon community had a perfect set of tiles. Thanks to Aaron Mulder for posting the Prison Cells set at http://www.drivethrurpg.com/product/242012/Best-of-the-Forums-Prison-Cells. With this set I was able to print out a replica of the room, where the middle two tiles can be lift and rotated to perfectly mimic the trap.



Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.